Copper capillary tubes are throttling components in refrigeration systems, primarily functioning to throttle and reduce pressure. The following precautions should be taken when using them:
1. The amount of Freon charged into the system must be precise. Once the diameter and length of the copper capillary tube are selected, its liquid supply capacity is fixed.
2. There should be no areas on the high-pressure side of the refrigeration cycle where refrigerant can easily accumulate. This prevents liquid from flowing into the evaporator when the compressor stops, which could cause liquid slugging upon restarting. Therefore, a liquid receiver should not be installed in the refrigeration system.
3. A filter should be installed before the copper capillary tube to prevent dirt from clogging its inner bore (known as dirt blockage).
4. The moisture content in the refrigeration system must be strictly controlled within the specified range to prevent ice blockage at the low-temperature outlet.
5. Because the refrigerant liquid maintains a relatively high temperature for most of its length after flowing from the condenser into the copper capillary tube, it only becomes cold at the very end. Therefore, in refrigeration equipment such as refrigerators, a 70cm section of the copper capillary tube near the condenser is often welded or wrapped together with the compressor's suction pipe to form a regenerator. This allows the condensate to exchange heat with the low-temperature refrigerant vapor, ensuring both superheating of the compressor's suction and supercooling of the condensate, reducing the generation of flash vapor within the copper capillary tube, thereby increasing the liquid supply and improving the cooling capacity.
6. Depending on the needs, several copper capillary tubes can be used in parallel. In this case, a distributor must be used, and careful adjustments must be made to ensure that the operating conditions of the copper capillary tubes are essentially the same.
7. The copper capillary tubes must be cleaned and dried, and the flow rate of each copper capillary tube must be measured before use.

